B&K 50 Series II Manual do Utilizador descarregar pdf (Página 35)

Configure CV Parameters

There are several parameters that should be set up prior to operating in CV mode. Press

so that it lights up, then press and to access Setup for CV mode. The

setup menu will be shown:

The setup parameters are: Range, High (Current limit), and Low (Current limit). Use the

key to select each parameter, and use the numeric keypad to change the value. Press

to confirm the change.

Range

Use the numeric keypad to change the range. This value will also act as a limit to how much

voltage the load can be configured to. The adjustable ranges vary depending on the model.

See specifications for details.

High

This parameter refers to the current high limit for the automatic test mode. During automatic

test mode, the device under test (DUT) must be operating below the configured value for the

test to PASS upon completion. If the DUT operates above the configured value, the test will FAIL

upon completion.

Constant Voltage

Range=60.000V

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 101 102

Sem comentários

B&K 50 Series II Manual do Utilizador Página 35