B&K 50 Series II Manual do Utilizador descarregar pdf (Página 36)

Note: This parameter is used for Automatic Test Function ONLY.

Low

This parameter refers to the current low limit for the automatic test mode. During automatic

test mode, the DUT must be operating below the configured value for the test to PASS upon

completion. If the DUT operates above the configured value, the test will FAIL upon completion.

Note: This parameter is used for Automatic Test Function ONLY.

Constant Resistance (CR) Mode

In this mode, the electronic load is equivalent to a constant resistance, as shown below. The

electronic load will linearly change the current, according to the input voltage.

Configure CR Parameters

There are several parameters that should be set up prior to operating in CR mode. Press

so that it lights up, then press and to access Setup for CR mode. The

setup menu will be shown:

Constant Resistance

Range=7500.0Ω

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 101 102

Sem comentários

B&K 50 Series II Manual do Utilizador Página 36