B&K 50 Series II Manual do Utilizador descarregar pdf (Página 79)

0 ≤ T

≤ (T

+ T

off

)

Tpf = P/F Delay Time

= On Time

off

= Off Time

Use the numeric keypad or rotary knob to enter a value. Then press .

8. If there are more than one active sequence, the load will repeat the prompts to

configure the On Time, Off Time, and P/F Delay Time. Follow steps 7 – 9 for each

sequence.

9. Once all sequences’ parameters are configured, the display will show:

Select Complete-Stop or Failure-Stop, then press .

Complete-Stop: Stop test when program is complete.

Failure-Stop: Stop test when testing fails.

10. The load will prompt to enter a value for Chain Program File. This specifies the next

program to run immediately after the end of the test. Select between 0 – 10. Select 0 if

no other programs will be run at the end of the test. Otherwise, select the program

number to run after the test is completed. Use the numeric keypad or rotary knob to

enter a value and then press to confirm.

11. Lastly, the load will prompt to select a number to Save Program File. This is the

program number that will be referred to when recalling all the configured settings from

previous steps or chaining with another program. Select between 1 – 10 with the

PROGRAM

Complete–Stop Failure–Stop

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 101 102

Sem comentários

B&K 50 Series II Manual do Utilizador Página 79