B&K 50 Series II Manual do Utilizador descarregar pdf (Página 81)

PRG01 from this display indicates which program has been loaded to run. Depending on

which program is recalled, it will show PRG01-PRG10.

STOP indicates the program is not running.

4. Now, press once to start running the program. The display will change to:

-01 next to PRG01 indicates the current running sequence number within the selected

program number.

on indicates the input state is enabled for the selected sequence. If On Time is not set

to 0.0S for the sequence, it will show on. This indicator can also show off to indicate the

input state is disabled. If short is selected for the sequence, it will display short.

pass indicates at the current sequence has passed the test. If a failure occurs, it will

indicate fail.

5. If pause is activated for a selected sequence while running the program, the display will

show:

10.000V

0.000A

PRG01 -01 on pass

OFF CC

10.000V

0.000A

PRG01 STOP

OFF CC

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 101 102

Sem comentários

B&K 50 Series II Manual do Utilizador Página 81