B&K 50 Series II Manual do Utilizador descarregar pdf (Página 83)

If there is a failure, fail will be indicated in place of pass. At this point, you can press

to view which sequences were tested and passed/failed. It will be indicated like

the following:

Y indicates the tested sequence(s) that passed/failed. If a sequence has been skipped in

the test, its sequence number will be indicated instead of a Y.

7. To stop a running program at any time, press once. To completely exit the

automatic test function, press a few times until the load returns back to the

normal display.

OCP Test Function

The load has a built-in OCP test function that can be used to automate testing for OCP

conditions. The load can save up to 5 OCP test programs into internal memory, which can be

recalled and run.

The OCP Test program requires the following parameters be configured before it can be run.

Voltage On Level

This is the minimum voltage level the load measures before the start of

the test.

Voltage On Delay

This is the delay time from when the Voltage On Level is reached to the

actual start of the test.

Current Range

This specifies the current range of the test. All models have two current

ranges, with the lower range allowing for higher resolution. This value

will also limit the maximum current settings for other parameters

configured for the test program.

10.000V

0.000A

PRG01: □□□□□□4Y2Y pass

OFF CC

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 101 102

Sem comentários

B&K 50 Series II Manual do Utilizador Página 83